fortinet support of third party trancievers

It will only offload if both ingress and egress ports belong to the same NP6 chip.ĬAPWAP Tunnel over the GRE tunnel (CAPWAP + TP2 card) is not supported.

All packet types are allowed, but depending on the network topology, an STP loop may resultĬAPWAP traffic will not offload if the ingress and egress traffic ports are on different NP6 chips.

HA may fail to form depending the network topology.

PDUs are dropped and therefore no STP loop results.

These issues have been improved in FortiOS 5.4.1, but with some side effects with the introduction of a new command, which is enabled by default:Ĭonfig global set hw-switch-ether-filter

Spanning tree loops may result depending on the network topologyįG-92D and FWF-92D do not support STP.

PPPoE failing, HA failing to form l IPv6 packets being dropped l FortiSwitch devices failing to be discovered.

Those issues, which were related to the use of port 1 through 14, include: FortiGate and FortiWiFi-92D Hardware LimitationįortiOS 5.4.0 reported an issue with the FG-92D model in the Special Notices > FG-92D High Availability in Interface Mode section of the release notes. SSL/HTTPS/SMTPS/IMAPS/POP3S options were removed from server-load-balance on low end models below FG-100D except FG-80C and FG-80CM. The IPsec option is no longer available and users should reconfigure in GUI or CLI to select the SSL encryption option as needed. In version 5.4, encrypting logs between FortiGate and FortiAnalyzer is handled via SSL encryption. For all 1U models and desktop models that supports SATA disk, log disk is enabled by default. For all 2U & 3U models (FG3600/FG-3700/FG-3800), log disk is also disabled by default. Default log setting changeįor FG-5000 blades, log disk is disabled by default. Special Notices Built-In CertificateįortiGate and FortiWiFi D-series and above have a built in Fortinet_Factory certificate that uses a 2048-bit certificate with the 14 DH group. To confirm that you are running the proper build, the output from the get system status CLI command has a branch point field that should read 1111.įortiOS 5.4.3 is a bug fix release with no new features.

As such, the System > Dashboard > Status page and the output from the get system status CLI command displays the build number.

The following models are released on a special branch based off of FortiOS 5.4.3. Supported modelsįortiOS 5.4.3 supports the following models. See the Fortinet Document Library for FortiOS documentation. This document provides the following information for FortiOS 5.4.3 build 1111:

Fortinet support of third party trancievers